2 ch DVB-S-S2 receiver board can be used to design and build various converters, transmodulators and other digital broadcasting equipment together with other our boards:
Thus 2 ch DVB-S-S2 receiver can be the part of:
Management, monitoring and configuration of 2 ch DVB-S-S2 receiver board is provided by TCP/IP using our IP control board.
KEY FEATURES:
- all types of satellite signal modulations (DVB-S/S2) are supported;
- small size of the board;
- low power consumption.
Video instructions about 2 ch DVB-S-S2 receiver board watch here 
Parameter |
Value |
Modulation types |
DVB-S, DVB-S2 |
Modulation parameters DVB-S2 mode |
Modulation |
QPSK, 8PSK (16APSK and 32APSK are supported in 1 channel mode) |
FEC |
1/4, 1/3, 2/5, 1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 8/9, 9/10 |
Symbol rate |
1 … 45 MSymb/s (8PSK);
1 … 38.7 MSymb/s (16APSK, 1 channel mode),
1 … 43 MSymb/s (16APSK, 1 channel mode, by request);
1 … 31 MSymb/s (32APSK, 1 channel mode),
1 … 34.5 MSymb/s (32APSK, 1 channel mode, by request);
in steps of 1 KSymb/s |
Roll-Off-Factor |
0.2, 0.25, 0.35 |
Modulation parameters DVB-S mode |
Modulation |
QPSK |
FEC |
1/2, 2/3, 3/4, 5/6, 7/8 |
Symbol rate |
1 … 45 MSymb/s, in steps of 1 KSymb |
RF parameters |
Frequency range |
950 … 2150 MHz, in increments of 1 kHz |
Input signal level range |
-80 … -20 dBm |
Connector type |
F-type |
Impedance |
75 Ohm |
Output |
Signal type |
parallel transport stream from DVB compatible modules |
Connector type |
PLD-34 |
General |
Control interfaces |
RS232 (in-built) |
TCP / IP (optional with IP-UART control unit) |
Front panel (optional with Front panel unit) |
Power supply |
8 … 18 V |
Power consumption, max |
5 W |
Dimensions |
148×82 mm |